1. Features of the Power over Ethernet Switch:
l 24*10/100M POE Ports + 2*Gigabit SFP/TP Combo Ports + 1*Console Port
l IEEE 802.3, IEEE 802.3u,IEEE 802.3af/at PoE compliant
l Support PoE IP camera, PoE WIFI AP, and PoE IP Phone.
l Fluid Control: Full-duplex: IEEE 802.3x, Half-duplex: back pressure
l Up to 15.4W/30W per port for powering PoE-enabled devices.
l One-key Smart: Support three working modes (N-Normal, V-VLAN, S-SUPM);
l All ports support wire speed switching, jumbo frame transmission.
l Support upstream ports lightning protection
l Dynamic power control to ensure stable output power (Enhanced).
l Improved anti-interference capability, to solve problems in the installation of grounding devices (Enhanced, twice as good as other manufacturers' products).
l Power-on in order of the PoE port, effectively reduce current strike, and reduce the transient voltage surge to PoE switch and other connected devices at the startup (Unique).
l Reliable short-circuit protection to ensure safety (Enhanced).
l Over-voltage and under-voltage protection (Some other manufacturers' products don't support this).
2. Descriptions of PoE Network Switch:
24 Ports PoE Ethernet Switch is an unmanaged Ethernet switch designed for Ethernet access and PoE applications. It provides 24*10/100M POE Ports + 2*Gigabit SFP/TP Combo Ports + 1*Console Port. The eight PoE ports support 802.3af/at standard and feature Max 30W PoE power output of each single port. This switch supports three kinds of working modes (N-Normal, V-VLAN, and S-SUPM). It can be widely used in security surveillance, hotels, schools, and SMB engineering and other occasions.
General Performance Indicator |
||
Product Name |
26 Port Gigabit Managed POE Switch |
|
Product Model |
|
|
Interface |
24*10/100M POE Ports + 2*Gigabit SFP/TP Combo Ports + 1*Console Port |
|
Network Protocols |
IEEE 802.3 IEEE 802.3u IEEE 802.3ab/ad/az/af/at IIEEE 802.3x IEEE 802.1q IEEE 802.1p.QoS IGMP Snooping |
|
PoE Parameters |
PoE Standard: IEEE802.3at (30W) and IEEE802.3af (15.4w) |
|
PoE compatibility: IEEE 802.3af/at adaptive |
||
POE port output: DC48-55V |
||
Power Pin Assignment: Power over spare pairs 1/2(+) and 3/6 (-) |
||
Port Lightning Protection |
General Mode 6KV, Differential Mode 4KV, ESD 15KV. |
|
Network Transmission Medium |
10BASE-T: Cat3, 4, 5 UTP (≤ 100 m) 100BASE-TX: UTP (≤100 m) above Cat5 1000BASE-TX: UTP (≤100 m) above Cat5 |
|
Optical |
Multimode fiber: 1310nm, 2Km Single mode fiber: 1310nm, 20/40 Km 1550nm, 60/80/100/120Km |
|
The LED indicator |
SYS, PWR, Link (lines 2, 4) / Act (lines 1, 3) |
|
Power Supply |
Machine input voltage: AC110-264V; Output: DC52V5.77A Total power: 300W |
|
Physical Dimension |
Product size (L×W×H): 410mm× 185mm× 45mm Package size (L × W × H): 468mm × 275mm × 80mm Product weight: 2.2kg Package weight: 2.8 kg |
|
Working Environment |
Operating Temperature:-20° ~ 55 ° C; Storage Temperature: -40 ° ~ 85 ° C; Operating Humidity: 10% ~ 95%, non-condensing Working height: up to 10,000 feet (3,000 meters) Storage height: up to 10,000 feet (3,000 meters) |
|
Certification |
CE, FCC,ROHS,3C |
|
MTBF: |
100,000 hours |
|
Package Contents |
1. Switch: 1 set 2. Instruction manual: 1 3. Certificate of conformity: 1 4. Warranty card: 1 5. AC power cord 1 6. A pair of hanging ears |
|
Warranty |
2 years warranty |
|
Technical Indicators |
||
Bandwidth |
12.8Gbps (non-blocking) |
|
Packet Forwarding rate |
9.6Mpps |
|
Processor |
IP1829A |
|
Flash Capacity |
128M |
|
Memory Capacity |
256M |
|
MAC |
16K |
|
Layer 2 Software Function |
||
Port Management |
Enable/Disable Port |
|
Speed.Duplex.MTU Setting |
||
Flow-control |
||
Port Information Check |
||
Port Mirroring |
Supports both side-way port mirroring |
|
Port Speed Limit |
Supports port-based input / output bandwidth management |
|
Port Isolation |
Support the downlink port isolation, and can communicate with the uplink port |
|
Storm Suppression |
Supports unknown unicast, multicast, unknown multicast, broadcast type storm suppression Storm suppression based on bandwidth regulation and storm filtering |
|
Link Aggregation |
Support static manual aggregation Support LACP dynamic aggregation |
|
VLAN |
Access |
|
Trunk |
||
Hybrid |
||
Support port, protocol, MAC-based VLAN partitioning |
||
Support GVRP dynamic VLAN registration |
||
Voice VLAN |
||
MAC |
Support static addition, deletion |
|
MAC address learning limit |
||
Support dynamic aging time setting |
||
Spanning tree |
Support STP spanning tree protocol Supports RSTP Rapid Spanning Tree Protocol Supports MSTP Rapid Spanning Tree Protocol |
|
Multicast |
Support static addition, deletion IGMP-snooping |
|
Support MLD-Snooping |
||
Support v1/2/3 dynamic multicast monitor |
||
DDM |
Support SFP/SFP+DDM |
|
Extended Function |
||
ACL |
Based on source MAC, destination MAC, protocol type, source IP, destination IP, L4 port |
|
Qos |
Based on 802.1p (COS) classification |
|
Based on DSCP classification |
||
Classification based on source IP, destination IP, and port number |
||
Support SP, WRR scheduling strategy |
||
Support flow rate limit CAR |
||
LLDP |
Support LLDP link discovery protocol |
|
User settings |
Add/delete users |
|
Log |
User login, operation, status, events |
|
Anti-attack |
DOS defense |
|
Support CPU protection and limits the rate of sending cpu packets |
||
ARP binding (IP, MAC, PORT binding) |
||
Certification |
Support 802.1x port authentication |
|
Support AAA certification |
||
Network diagnosis |
Support ping.telnet.trace |
|
System Management |
Device reset, configuration save/restore, upgrade management, time setting, etc. |
|
Management function |
||
CLI |
Support serial port command line management |
|
SSH |
Support SSHv1/2 remote management |
|
TELNET |
Support telnet remote management |
|
WEB |
Support Layer 2 settings, Layer 2 and Layer 3 monitor |
|
SNMP |
SNMP V1/V2/V3 |
|
Support trap:ColdStart.WarmStart.LinkDown.LinkUp |
||
RMON |
Support RMON v1 |
|
POE |
Support PoE power supply |
|
Other functions |
Support DHCP Snooping.Option82 |
|
Support dynamic ARP detection |
||
Support TACACS+ certification |
||
Support DNS certification |
||
Support port security settings |
||
Support MVR protocol |
||
Support cable detection VCT function |
||
Support UDLD protocol |